€15,00 – €42,51
PREMIUM stain contains boiled linseed oil, mineral pigments and nature-friendly alternative material to biocides. Highlights wooden structure. Fine ground pigments provides an even coating, protecting surface from UV (ultraviolet) rays. Protects from moisture in long-term, does not peel or crack. Surface is easily renewable.
APPLICATION: Outdoors and indoors (P-11, P-12). For wooden surfaces – facades, walls, ceiling, floors, furniture, wooden toys etc.. Can be used on uncoated surfaces, as well as for previously oiled surfaces. Widely used for restoration projects.
DRYING TIME: 18 hours at temperature of +20 (± 2) ̊C. Low temperature, high humidity and wood moisture content can result in extended drying time.
PREPARATION OF THE SURFACE: surface must be dry and clean, free from dust and with no rosin residue. Moisture content of wood cannot exceed 18%. Product can be used only if the surface has been cleaned of previous coat(s) of chemical coating. It is recommended to use the product in average temperatures between +10 ̊C – +25 ̊C. Do not use on a sun heated surface. Before applying product on finely polished surface, we recommend using boiled linseed oil as primer.
CONSUMPTION. 1 liter in a single coat covers: rough sawn timber ~ 6-8 m2, planed timber ~ 12-15 m2, hardwood ~30-36 m2. Consumption for second layer will decrease by ~ 25%. These consumption parameters are indicative; your consumption might differ from these parameters.
OUTDOORS. Recommended to coat in two layers.
Thoroughly stir the product before and during use. Dilute it with natural turpentine (up to 5%). For application use short bristle brushes, rollers and sprays (paint must be specially prepared). First layer must be applied evenly, layer has to be as thin as possible. Allow the product soak in for 20-30 min. Thoroughly wipe excess product with a clean cloth or paper towels. There is no need to wipe excess stain from rough sawn timber, distribute excess product across the surface. Allow the surface to dry for at least 18 hours before applying the second layer. For second layer apply non-diluted stain. Course of work is identical as for application of first layer.
INDOORS. Recommended to coat in one layer – floor staining. Dilute stain with natural turpentine (up to 5%). Layer must be applied evenly and has to be as thin as possible. Allow the product soak in for 20-30 min. Thoroughly wipe excess product with a clean cloth or paper towels. for extra protection, no less than after 18 hours apply PAINT ECO Hard wax oil (refer to instruction for use of Hard wax oil).
Recommended to coat in two layers – places with high humidity (bathrooms, saunas, etc.). For second layer apply non-diluted stain. Course of work is identical as for application of first layer.
TOOL CLEANING: We recommend to clean it with natural turpentine or warm water and soap.
STORAGE: up to 3 years and longer if can is kept dry, in a room temperature and closed tightly.
Do not expose to direct sunlight. Do not store it together with food.
Discs and polishing cloths used during floor lubrication must be placed in a container with water after the use to prevent their self-ignition! Keep out of reach of children!